|
> Using
the Stereo Digital Inputs
<
The VS-2480 has both SPDIF coaxial and optical inputs
and outputs. Use the following procedure to setup the VS-2480 to
''clock'' to an incoming digital:
1. Press UTILITY.
2. Press the PAGE button so that Page 1 is selected.
3. Press F3(Proj).
4. Use the CURSOR buttons so that the Cursor is in the ''MASTER CLOCK''
section.
5. Use the TIME/VALUE dial to highlight COAXIAL IN or OPTICAL IN,
depending on which input you are going to use.
6. Press the ENTER button to change the Master Clock from ''Internal''
to the selected input. Depending on your choice in step 5, ''Coaxial In
Lock'' or ''Optical In Lock'' will be displayed.
You will also need to route the digital signal to a pair of channels on
the input mixer. Use the following procedure to route the COAXIAL IN or
OPTICAL IN to input Channels 1/2:
1. Press EZ ROUTING.
2. Using the CURSOR buttons, highlight 1/2 on the top row of the input
mixer.
3. Rotate the TIME/VALUE wheel so that a connection is made from 1/2 and
COAX LR (or OPT LR) at the top of the screen.
4. Press DISPLAY/HOME to exit EZ ROUTING.
At this point the Input faders for channels 1 and 2 will control the
amount of incoming signal from the Coaxial (or Optical) in.
(Back to Inputs/Outputs/Signal
Routing) |
RolandVS2480.net
~ Roland VS-2480 Tech Help Website
