|
>
Assigning
a Single Input to Multiple Tracks <
(Using VGA Screen)
The VS-2480/2480CD is capable of simultaneously
recording 12 tracks from a single input. This is useful if you want to
quickly record several takes from the same input to multiple tracks. Use
the following procedure to assign input 1 to multiple channels of the
input mixer, and route those channels to consecutive recording tracks:
1. Connect your source to Input 1 of the VS-2480.
2. Utilizing the menu at the top left of the VGA monitor, point and
click on EZ ROUTING/ROUTING VIEW.
3. Find the PATCH BAY section in the upper left quadrant of VGA Monitor
and point and click on the INPUT MIXER 3 and 4.
4. Use the mouse to connect the lines from INPUT MIXER 3 & 4 to
ANALOG INPUT 1 & 2. NOTE: Because of the specific architecture of
the VS, the routing of analog inputs to the input mixer are made in
pairs - even if only 1 input is used, the analog inputs are routed
together.
5. Repeat the procedure in step 4 to connect Input Mixer 5 & 6 thru
23 & 24 until all 24 mixer channels are connected to Analog Input 1
& 2.
6. In the TRACK ASSIGN section in the lower left quadrant of the VGA
Monitor, point and click on INPUT MIXER #3 and connect the line to
RECORDING TRACK 2.
7. Assign all odd INPUT MIXER numbers to 12 consecutive RECORDING TRACKS
(i.e. INPUT MIXER 5 to RECORDING TRACK 3; INPUT MIXER 7 to RECORDING
TRACK 4 etc.)
8. At this point, the signal coming in Input 1 will be sent to all odd
Input Mixer channels, and then subsequently sent to consecutive tracks
(1-12). Set the INPUT SENS for Input 1 and raise all odd Input mixer
channels to 0db before recording.
(Back to Inputs/Outputs/Signal
Routing) |
RolandVS2480.net
~ Roland VS-2480 Tech Help Website
